Club-S12 International S12OC United Kingdom ClubS12 France S12Silvia Australia S12.org.ua Eastern Europe S12 of Sweden S12 Japan BBS



Please login or register.

Login with username, password and session length
[History] [Commands]

[Today at 02:10:13 AM] SchizophrenicMC: lol

[Today at 02:12:08 AM] SchizophrenicMC: I think tomorrow I'm gonna solder all the bad solder joints in my Jeep

[Today at 02:13:12 AM] StephenG: Buy a gun, its the single best thing you can possible do to keep your sanity

[Today at 02:13:37 AM] StephenG: soldering gun*

[Today at 02:13:41 AM] SchizophrenicMC: lol

[Today at 02:13:56 AM] SchizophrenicMC: The joints I'm soldering are all board joints

[Today at 02:14:19 AM] SchizophrenicMC: That is, this little 10A iron is sufficient

[Today at 02:14:29 AM] StephenG: oh, nvm then. Wont want to use it on anything with ICs

[Today at 02:14:38 AM] SchizophrenicMC: lol

[Today at 02:14:50 AM] SchizophrenicMC: There are maybe 4 ICs in this whole damn Jeep

[Today at 02:15:33 AM] SchizophrenicMC: But it's got a bunch of boards with various shit connected to them

[Today at 02:19:06 AM] SchizophrenicMC: I might install this vehicle information center in place of the graphical display module

[Today at 02:19:41 AM] SchizophrenicMC: If I do, I'll have to jury-rig this arduino into a device for mocking up sensor signals I don't have

[Today at 02:19:59 AM] SchizophrenicMC: Like the coolant level sensor and wiper fluid level sensor

[Today at 02:31:05 AM] StephenG: sounds like fun

« previous next »
Pages: [1]

Author Topic: Rb20det Gears Installed  (Read 912 times)

Offline falkhen

  • Full Member
  • ***
  • Location: Greater Houston Area
  • Posts: 773
Rb20det Gears Installed
« on: 11:30:40 PM / 06-Aug-07 »
i got my gears last weekend and was going to install them, but a hot motor close clearances made me think about that again. so i waited till saturday morning to install them. I got Great Deal on the Nico Forum

Nico Forum Group buy (Cam Gears)






i had to take my radiator out. becuase there is less then 4"s of room.

the whole ordeal took 1.5hr's

Logged

Offline Frank

  • Full Member
  • ***
  • Location: quebec, canada
  • Posts: 287
    • http://
Rb20det Gears Installed
« Reply #1 on: 03:26:47 PM / 07-Aug-07 »
i heard you can get like 10whp by retarding the intake 3 degrees and advancing the exhaust 4 degrees on the rb20 engine without losing low rpm power

basicly you put a little more overlap by doing this and it boost up mid/hih rpm power alot ... well 10whp is alot for me if you consider it's just cam timing !
Logged
Pages: [1]
« previous next »