
1987 Nissan S12 |
|
Videos |
There are currently no videos attached to this vehicle. |
Modifications |
Modification |
Rating |
Price |
Install Cost |
Created |
Updated |
|
E-Motor USA 38MM External Wastegate | 7 | 70.00 | 0.00 | July 2nd, 2013, 10:28 pm | July 2nd, 2013, 10:28 pm | |
E-Motor USA Top Mount T3 Cast Turbo Manifold | 10 | 80.00 | 0.00 | July 2nd, 2013, 10:25 pm | July 2nd, 2013, 10:25 pm | |
Garrett T3 Turbo | 8 | 0.00 | 0.00 | March 4th, 2013, 7:27 pm | March 4th, 2013, 7:27 pm | |
Nissan S13/S14 5-speed Manual Trans | 8 | 125.00 | 0.00 | January 27th, 2011, 10:40 pm | January 27th, 2011, 10:40 pm | |
Williams Fabrication Midship Chassis Brace | 5 | 0.00 | 0.00 | January 10th, 2011, 8:49 pm | January 10th, 2011, 8:50 pm | |
JDM Sport 23" X 8" X 3" Intercooler | 8 | 80.00 | 0.00 | October 10th, 2010, 2:29 pm | October 10th, 2010, 2:29 pm | |
Unknown Knock-off "Greddy" Type-RS Blow-Off Valve | 6 | 50.00 | 0.00 | October 10th, 2010, 2:25 pm | October 10th, 2010, 2:25 pm | |
Innovate Motorsports LC-1 Wideband Controller | 10 | 199.95 | 0.00 | October 10th, 2010, 2:15 pm | October 10th, 2010, 2:15 pm | |
Nissan Front Tension Rod Brackets | 8 | 0.00 | 0.00 | October 9th, 2010, 9:58 am | October 9th, 2010, 9:58 am | |
Williams Fabrication Solid Transmission Mount | 10 | 0.00 | 0.00 | October 9th, 2010, 9:53 am | October 9th, 2010, 9:53 am | |
Nissan Rear Differential Mount | 10 | 0.00 | 0.00 | October 9th, 2010, 9:48 am | October 9th, 2010, 9:48 am | |
BartCo Original Strut Tower Brace | 7 | 0.00 | 0.00 | October 9th, 2010, 9:43 am | October 9th, 2010, 9:43 am | |
Bendix CQ Ceramic Pads | 7 | 50.00 | 0.00 | October 3rd, 2010, 7:07 pm | October 3rd, 2010, 7:07 pm | |
Nissan S12 R180 Rear Differential | 6 | 0.00 | 0.00 | September 12th, 2010, 1:01 pm | September 12th, 2010, 1:01 pm | |
Nissan S12 Rear Suspension Subframe | 10 | 0.00 | 0.00 | September 12th, 2010, 12:57 pm | September 12th, 2010, 12:58 pm | |
Bosch Automotive 023 High Pressure Fuel Pump | 10 | 169.99 | 0.00 | September 12th, 2010, 12:44 pm | September 12th, 2010, 12:50 pm | |
Nissan RWD SR20DET FS5W71C Bellhousing | 7 | 265.84 | 0.00 | September 12th, 2010, 12:34 pm | September 12th, 2010, 12:34 pm | |
Nissan RWD SR20DET Flywheel | 7 | 60.00 | 0.00 | September 12th, 2010, 12:30 pm | September 12th, 2010, 12:47 pm | |
Nissan 1994 S14 SR20DE | 10 | 405.00 | 0.00 | September 12th, 2010, 12:10 pm | September 12th, 2010, 12:54 pm | |
Prothane 14-303 Control Arm Bushing Kit | 10 | 16.55 | 0.00 | September 12th, 2010, 12:06 pm | September 12th, 2010, 12:06 pm | |
Bowling & Grippo MegaSquirt I | 10 | 0.00 | 0.00 | September 12th, 2010, 12:03 pm | September 12th, 2010, 12:48 pm | |
DeatschWerks 450CC/min Injectors | 8 | 239.00 | 0.00 | September 11th, 2010, 8:28 pm | September 11th, 2010, 8:28 pm |
¼ Mile Runs |
R/T |
60 Foot |
330 Foot |
1/8 Mile |
1/8 MPH |
1000 FT |
1/4 Mile |
1/4 MPH |
|
0.000 | 0.000 | 0.000 | 0.000 | 0.000 MPH | 0.000 | 14.000 | 99.800 MPH |
Dynoruns |
There are currently no dynoruns attached to this vehicle. |
Laps |
There are currently no laps attached to this vehicle. |
Premiums |
There are currently no premiums attached to this vehicle. |
Services |
There are currently no services attached to this vehicle |
Pages: [1] |
Brake pads, part 2Pads are install and after a few heat cycles, they stop awesome. 1000x better than the old cheap-o pads I had. I would recommend them to anyone! If anyone else wants them, they are available from RockAuto under the D274 and D272 parts (D274 is listed for an 83 Maxima, but the D272 are 200SX). |
|
Quest for decent cheap brake padsHere I go again, time for new pads, just about nothing left in the rear, about 40% up front. Bought from Bendix CQ ceramic pads, front and rear. It's really hard to find good front pads for the XE S12, no problem for the SE or turbo though (they got the bigger front calipers). At least all S12's got the same rear calipers, so that's not a problem. The front pads are the D274 pads, though they're listed for an 83 maxima. Not sure why they don't list them for the XE S12s, since they're the same model pad, but if they don't fit I'll know why soon enough. I should have them Thursday (10/7/2010), only paid $54 for them shipped from RockAuto. Hopefully they'll grip better than the $10 specials I have on now, which barely give one good stop before giving up and can't even lock the fronts anymore. |
|
Some videosA fly-by, with open exhaust! [youtube]http://www.youtube.com/watch?v=EtyMFHALnko[/youtube] My burn-out at our local cruise night last year, crappy video, couldn't get a good shot. It's coming up again, so maybe some better this year. :D [youtube]http://www.youtube.com/watch?v=8N133MmRFkM[/youtube] |
Pages: [1] |
Author |
Message |
|||||
Romero
|
|
|||||
Romero
|
|
|||||
seishuku
|
|
|||||
Xano
|
|
|||||
Powered by SMF Garage 2.1 | SMF Garage © 2007-2022 |