what did you do to your s12 today?!

[Jay]

Haha, today I put in a new water temp sensor,  put in a new diehard battery,  and got my sweet nismo key chain in the mail,  check it.

You just reminded me.
I have NO fucking clue as to where my S12's Keys are.
Oh well. I don't "need" them anyways... It just starts easier using the cylinder

[imtheguy247]

Knocked on Start Solenoid, Cleaned MAF Sensor, Cleaned up windshield( Soda Spilt all over it). O and also decided to put my seatbelt back in

[Prolowtone]

Redid my timing as i had rushed it last time and have messed around with some stuff and fix a vac leak on my car since. Re soldered a wire, labeled what pin is what on my mega squirt loom. got bored and used up some of the 5 rolls of electrical tape sitting in my car. Cleaned up some of the gunk off of my CA18DET and B trans

[heith]

almost ready for clear coat on my paint job

[Kustamogen]

got all the gravel from out of my wheel wells....it was affecting my door opening abilities lol

[heith]

i came to the conclusion that i hate over spray when painting my car panda

[Jeremy A]

Heith,  I'd absolutely love to see some some photos bro,  I dig a nice panda scheme.

[Kustamogen]

Im semi-panda....I was thinking of painting under the molding black......been thinking of doing that the last couple years

[Jay]

Just don't do it with spray paint while stumbling over drunk... That's what happened here. Lol

[backwoodsbuilder]

cleaning 20e degreasser+brush=mess lol  went to pull timing gear off front and couldnt get the damn thing off so i got cut off wheel out and well its off and pulled pan & oil pump

[heith]

my paint job turned out alright. it wont win any paint awards but it is a whole lot better then the faded red.
Post Merge: 07:18:02 PM / 13-Mar-11
i will try to get some pics up when i get all the tape off and and everything back on the car

[Maxpow]

cut like 200lbs of metal off of the Squirl. Can't wait to recycle her.

[heith]

nissan canada told me that the lower coolant hard pipe that is pressed into the block is a discontinued part? going to call them and see what my options are...

[Jeremy A]

I fixed my horn today,  I wasn't expecting it to sound the way it does,  pretty high pitched 

i will try to get some pics up when i get all the tape off and and everything back on the car

I'm looking forward to the pics heith!  (It'll for sure be nicer then the attempt in Jay's post)  Haha, really though, if you did that while stumbling over drunk Jay,  you must do some very decent shit sober my friend.  Or whoever did the painting.

[Jay]

Attempt?!
You think that was an attempt?!
That was a drunken joke taken into reality, not an attempt.

(Nothing about that paint job was good, so it was perfect for what we were going for. One, big, joke)

[Prolowtone]

Cleaned up the inside a little bit. played around with the ignition and now it makes the ding noise again when i turn my car to the on position. Now if the bitch will talk again, she did for a day when i got the car but quickly jumped ship.

[Jay]

Tried to start it with a nearly dead battery.
It didn't start....
And then it did start....
And then, it sputtered out....
and then it wouldn't start again....
Now it's hooked up to the battery charger... So it can start

[Maxpow]

Yeah I jumped mine today, and it finally stays on. Died out a few times but I think that was just the last of the bad gas leaving.

[Jay]

My alternator doesn't excite right away. So what happened was there wasn't enough juice for the coil to make it up to the 1500 rpm excitation. (Which, no, is not normal, but I don't care)
Started A-ok about 20 mins ago

[seishuku]

Heh, your alt does the same thing mine does... Doesn't power up until 2k RPM, and when it does I get 15 volts.

I just replaced my front main seal... again... because I dicked up a long time ago and scratched the seal bore, and if it's not sealed quite right it leaks bad.
I'm trying a different sealant this time, hopefully it holds.