[PA - Phila] complete CA20E engine w/ 5 speed trans FS - pickup only!

sinerje · 03:08:32 PM / 23-Jan-11

i have a complete 1986 CA20E engine and 5 speed transmission that i just pulled out of my project car. the motor ran and the car drove before pulling it - unfortunately i do not have video of the engine running prior to removal and i will say that the engine did smoke for the first few days until it was warmed up, most likely due to prolonged sitting and dried out valve guide seals. it did not smoke after being driven a few days in a row plus it did not run hot or ever break down on me. it has a KA24DE throttle body swapped onto it but comes with the original too. the car has just over 172K on it. it is located about 35 minutes outside Philly PA and comes pretty much complete, as you can see in the pics i've included. i have the fan, alternator, and other misc. parts. the distributor cap is off so it could sit closer to the wall since space is at a premium in my garage. i will sell the engine + trans complete or engine and transmission separately or will part them out. $300 for both / $150 for the engine / $175 for the trans. will ship smaller parts (throttle body, alternator, exhaust manifold, etc). make me a reasonable offer for whatever but no trades, thanks!

Jay · 03:20:11 PM / 23-Jan-11

A reasonable offer for the value of this engine and transmission is going to be vastly lower than you're expecting.

IF the trans was priced at 150. You might, just might have a buyer. Considering there's a C trans with 43k miles in PA for 225 at a junkyard (Which is about right for the mileage)

1987
Transmission
Nissan 200SX 9-86 TESTED ON LIFT 43,000 A 418345 $225 Capitol Auto Parts USA-PA(East-Bangor) Request_Quote 1-800-360-3131 Request_Insurance_Quote

173k CA20E = 100 dollar motor.
125k KA24de = 250 dollar motor

Just putting out a strong suggestion to lower your price significantly for whole.
Or sell individual parts. People across the pond LOVE our intake manifolds, and will pay for it too.

sinerje · 03:28:29 PM / 23-Jan-11

Quote from: Jay on 03:20:11 PM / 23-Jan-11
Good luck.....
All I will say

hey, i was just reading your build thread, lol.
advice taken.

Jay · 03:30:38 PM / 23-Jan-11

:You caught me in the middle of an edit

That's much closer to market value. Carry on!

BoostedVG · 06:42:54 PM / 23-Jan-11

Just curious what direction from philly? Its rare there is anyone close from the east coast. Good luck with your sale

sinerje · 08:48:47 PM / 23-Jan-11

Quote from: BoostedVG on 06:42:54 PM / 23-Jan-11
Just curious what direction from philly? Its rare there is anyone close from the east coast. Good luck with your sale

i'm near Lansdale... i used to be out your way a lot when i hung out in Pottstown.

Jay · 08:50:22 PM / 23-Jan-11

Quote from: sinerje on 08:48:47 PM / 23-Jan-11
i'm near Lansdale... i used to be out your way a lot when i hung out in Pottstown.

My brother lives in pottstown.
Quaint place

sinerje · 02:53:09 AM / 26-Jan-11

Quote from: Jay on 08:50:22 PM / 23-Jan-11
My brother lives in pottstown.
Quaint place

depends on where in pottstown, hehe.

s12beast87 · 08:38:44 AM / 26-Jan-11

Yeaah more east coast nutheads!

sinerje · 11:13:35 AM / 04-Feb-11

Quote from: s12beast87 on 08:38:44 AM / 26-Jan-11
Yeaah more east coast nutheads!

yup. that's for sure

rom-s12 · 05:02:53 AM / 05-Feb-11

hello
What is your price of admission to the collector of your engine?
would it be possible to send the piece in France and at what price?!
thank you.

Jay · 02:15:21 PM / 05-Feb-11

^
Translated. Price for intake manifold shipped to france
(Collector = intake manifold)

rom-s12 · 04:24:59 PM / 05-Feb-11

Quote from: Jay on 02:15:21 PM / 05-Feb-11
^
Translated. Price for intake manifold shipped to france
(Collector = intake manifold)

thank you